Oak Bluffs, MA old classifieds archive and funnies > By Year
> 2009
> Stepper motor control&driver board ii (2 control modes)
Stepper motor control&driver board ii (2 control modes)
Stepper Motor Control & Driver Board II (2 Control Modes)
This stepper motor control&drive board has two control modes switched by jumper JP1:
1. By pulse and signals (JP1 Removed)
Input pulse and signals to control the motor run, stop and direction.
2. By buttons (JP1 Mounted-On)
There are 3 buttons marked "INC""DEC""FUN" on the board, you can press them to control stepper motor accelerate/decelerate, CW/CCW, stop etc.
For the board's flexibility (it can work even without pulse), so it suit for experiment demo, prototype making, student training, people DIY etc.
1. Matching motors: 6 wires stepper motor, 2-phase or 4-phase, amperage<4A.
2. Operation volage: 5VDC for the board, 9-40VDC for stepper motor.
3. Motor speed can be adjusted and memorized.
2. Control by pulse and signals (JP1 Removed)
9-40VDC for stepper motor: VCC, GND
Input pulse: CP (standard pulse: low 0V, high 5V)
3. Control by buttons (JP1 Mounted-On)
9-40VDC for stepper motor: VCC, GND
INC: Acceleration (One time of pressure, one speed level upgraded. You will find it turn faster apparently after several times of pressure.)
DEC: Deceleration (Though CCW run, you will find it slow down apparently after several times of pressure.)
(Suggest you can mount-on JP2 after speed adjustment, then it be memorized even power off.)
Please turn off power supply before you mount-on or remove the jumpers.
Any other question, please feel free to contact me. I will reply your message in 24 hours.
Nomally, The delivery time of airmail is 7-15 business days.
